Thermal printing with direct thermal paper can last for about 7-15 years, while those printed on premium thermal transfer paper can last for 20-25 years depending on the ribbon type you use. Synthetic media can last for at least 20 years.
When should I replace my zebra printhead?
A printhead should be expected to print up to ten million labels before needing to be replaced. However, without the proper maintenance and care, this can reduce to as little as one million. With attention and care, you can prevent this burnout and extend the life of your printhead.
How do I reset my zebra zm400 printer?
Press and hold the Pause and Feed buttons simultaneously and turn the power switch back on. Continue holding the Pause and Feed buttons until the printer begins its calibration process. Release the buttons when the printer begins to feed labels through the printer.
What does resetting a Zebra printer do?
When it flashes four times, release it. This resets the printer to factory defaults.
What printheads do the zm400 and zm600 work with?
Specifically, the ZM400 and ZM600 are designed to work only with genuine Zebra™ printheads, thus maximizing safety and print quality. Table 1 • Kit List
Is Printhead a registered trademark of zebra?
Printhead Conversion Kit © 2007 ZIH Corp. All product names and numbers are Zebra trademarks, and Zebra and the Zebra logo are registered trademarks of ZIH Corp. All rights reserved.
How do I prepare for installation 7/27/07 zm400/zm600?
Prepare for Installation 7/27/07 ZM400/ZM600 Installation Instruction 79805L-001 B Remove the Electronics Cover 1. Open the media cover and remove the media and ribbon. 2. See Figure 2. Remove the screw and washer securing the electronics cover. Figure 2 • Locate the Electronics Cover Mounting Screw 3. Close the media door.
What happened to my Zebra printer?
This printer is discontinued. We may offer drivers, firmware, and manuals below for your convenience, as well as online tech support. If you require additional support, please contact a Zebra Authorized Service Provider. A recent Microsoft Windows update has been identified to cause the following issues when attempting to print to certain printers.
