Adjusting Reach on Tektro Hydraulic Brake Levers
- Step 1: Identify the reach adjustment screw. The reach adjustment screw is a set screw located inside of the brake lever.
- Step 2: Adjusting Reach. Use a 2mm hex key to adjust reach.
- Step 3: Check Brake Performance.
How do I tighten my Tektro brakes?
Squeeze the brake lever tightly with one hand while tightening the mounting bolt with a hex wrench. This will center the brake so that the pads contact the rim at exactly the same time. Loosen the cable stop on the left side of the brake with a hex key so that the cable moves freely through it.
What do I need to service my tektro hydraulic disc brake?
You will also need a Tektro hydraulic disc brake service kit, which should include a syringe, 2 lengths of plastic tubing, an outlet valve, and a bottle of Tektro hydraulic brake fluid (mineral oil). Make sure to use the specific type of oil for this brand, as using other types could damage your system.
How hard is it to adjust disc brakes?
If you have not had previous experience adjusting disc brakes don’t worry, it is not hard to do! On the inside of the rotor: you will have a brake pad that does not move. You can adjust the position of this pad in and out until it is as close to the rotor as possible without touching it using the Allen bolt on the inside of the brake.
How do I adjust the position of the brake pads?
On the inside of the rotor: you will have a brake pad that does not move. You can adjust the position of this pad in and out until it is as close to the rotor as possible without touching it using the Allen bolt on the inside of the brake. On the outside of the rotor: you will find a brake pad that moves in and out with the brake lever.
How do you change the oil in a Toyota Corolla disc brakes?
Remove the disc brake pads and slide a piston block or 10mm allen wrench into the gap to keep the pistons in place. Remove the rubber cover from the bleed outlet valve on the brake caliper. Attach the smaller tube from your service kit onto the syringe and fill your syringe about halfway with oil.
