In general the length to choose for gas struts is about 55% of the height of the door you are trying to keep open. So if you have a door that is 1000mm in height a 550mm long gas strut would be about right. In simple terms we are talking half the door height plus a bit when determining optimal gas strut length.
Can gas struts be repaired?
For the gas strut repair, the strut must be removed from the host equipment and sent to our workshop for a free inspection. We will then advise you if a re-gas will be successful or economical. The struts are tested and gassed on the day they are received and shipped back using a next-day delivery service.
How do I choose a gas spring?
Follow these steps to calculate a gas spring:
- Decide what you want to use the gas spring for.
- Enter the dimensions of the application.
- Measure the thickness of the application.
- Investigate which material the application is made of.
- Determine the total weight of the application.
- Determine the position of the pivot point.
How do you install a Snugtop?
Installation Instructions for a Snugtop Lid
- Wipe the bed rails with an alcohol wipe.
- Apply the 1 1/2-inch bed tape to the four sides of the bed rails and to the rails of the Snugtop lid.
- Set the Snugtop lid in place, so the bed tape on the bed and lid rails match up.
How do you remove Snugtop?
Use the flathead screwdriver to pry off the clips on the ends of the shocks, the ones on the bed. Pry them off and then pull the shocks off the bed rail mounts. This is going to release the tonneau cover from the bed, so make sure your assistant has a firm hold on the tonneau, otherwise it could slam on your hands.
Should I be able to compress a strut by hand?
You can compress it if you lean into it with one end on the ground. And is should bounce back.
