Standard Ford 289 and 302 small-blocks were factory-rated between 200 and 230 hp. The vaunted 289 High-Performance engine was said to make 271 hp. Today, if a 302 Ford makes 360 hp on pump gas with a hydraulic cam, most experts consider it to be a pretty good motor-at least until Joe Sherman steps up to the plate.
How can I get more horsepower out of my Ford 302?
How to Get the Most Horsepower Out of a Ford 302
- Install a performance aftermarket cold air intake to replace the Ford 302 factory air intake.
- Install a performance aftermarket exhaust system to replace the Ford 302 factory exhaust system.
- Install a forced induction — supercharger or turbocharger — kit.
How much HP does a 69 302 have?
Engine Specs (302 cid V8)
| Spark Plugs | |
|---|---|
| Compression | 9.5:1 (155 – 199 psi @ cranking speed), 9.0:1 5.0L |
| Compression Pressure | 130-170 @ cranking speed |
| HP and Torque | 210 or 225 (HO) hp at 4400 RPM and 158 ft/lbs torque at 2400 RPM |
| Taxable HP | 51.2 |
How much horsepower does a 1978 302 have?
Engine Basics
| Year | 1978 |
|---|---|
| Power (hp) | 139 hp @ 3,600 RPM |
| Torque (lb/ft) | 250 lb/ft @ 1,600 RPM |
| Compression | 8.4:1 |
| Displacement | 302 cu / 4.9 liters |
How much does it cost to have a 302 rebuild?
how much does it generally cost to rebuild a 302 winsor? your average rebuild with average machine work should be around $800.
Is the Ford 302 a Windsor?
The Ford 302 is technically called the 302 Windsor and was first manufactured in Ford’s plant in Windsor, Ontario. Not all 302s were built in the Windsor plant, but all retained the name. The standard 302’s power ranged from 210 to 230 hp, depending on the carburetor.
How do you get a 300hp out of a 302?
The best way is to yank the 302 and throw in a 5.0 HO from a mustang gt with the roller cam and just add some TW heads or afr 165’s and the above(int, carb, headers) you will have more than 300hp with great low end TQ and fuel economy.
What can a 302 be stroked to?
Ford Based 302 Small Block Mild stroker setup, using a 3.250″ stroke to achieve a displacement of 331 cubic inches. Balanced top and bottom end power makes it ideal for many uses.
How can you tell a 302 block?
Some 302 cubic inch engines have the designator “302” cast into the block in the valley between the cylinder banks at the top of the engine.
Is there a 302 Windsor?
The Ford 302 is technically called the 302 Windsor and was first manufactured in Ford’s plant in Windsor, Ontario. It was a modern improvement from the older Y-block ford V-8s. Not all 302s were built in the Windsor plant, but all retained the name.
How much does it cost to replace a 5.0 engine?
Expect to pay between $8000.00-$10,000to r&r a rebuilt engine. Labor costs for installing a ford f150 engine (year 2019) are estimated between $454 and $574 while parts are priced between $104 and $150.
