The XR06CX, format 32 x 74 x 60 mm, is microprocessor based controller, suitable for applications on medium or low temperature ventilated refrigerating units. It has three relay outputs to control compressor, fan, and defrost which can be either electrical or reverse cycle (hot gas).
How do you set a dixell thermostat?
To Check Temperature Setting: Press and hold in the set button for 5 seconds to see the temperature setting. To adjust the temperature setting use the up or down arrow. **normal setting is 4 degree F.
What does ha mean on dixell controller?
Its troubleshooting guide says the control flashes “HA” if the internal compartment temperature has exceeded the high temperature alarm preset value for over 30 minutes.
How do you reset a dixell controller?
Resetting the Temperatures
- With either the maximum or minimum temperature displayed, press and hold the SET button for more than three seconds. The “rSt” message will display on the screen.
- The controller confirms the reset by having the “rSt” blink. After this, the normal temperature will display on the screen.
Who makes dixell controller?
Emerson US
Dixell: Industrial & Commercial Electronic Regulation and Control | Emerson US.
How do you reset a Dixell controller?
With either the maximum or minimum temperature displayed, press and hold the SET button for more than three seconds. The “rSt” message will display on the screen. The controller confirms the reset by having the “rSt” blink. After this, the normal temperature will display on the screen.
What does P2 mean on freezer?
P2 error code indicates you that your system has a high temperature protection of the compressor. This can relate to a faulty outdoor mother board, your system being low on refrigerant or restriction in the pressure and a defective sensor.
What are P2 codes?
P2 or FL Error Code. The P2 or FL error code (depending on model) indicates that the drain pan in the unit is full. Under normal operating conditions, the drain pan will not need to be emptied.
